The RUGID Community
Read and participate in active technical discussions with the RUGID community all over the world.
"Watch" while both serial ports are in use
Forum rules
To help everyone get the most out of the forums and keep this a friendly place containing useful information please keep in mind the following guidelines:
-Keep discussions professional and on topic.
-If you need immediate support please email support@rugidcomputer.com. While support forums are monitored they are not the primary means of getting support. However chances are that someone else may have/had your same question.
-Any personal attacks, insults, rants, bad language or abuse of support staff or other forum users will result in deletion of such posts and immediate termination of forum access.
-Smile and have a great day!
To help everyone get the most out of the forums and keep this a friendly place containing useful information please keep in mind the following guidelines:
-Keep discussions professional and on topic.
-If you need immediate support please email support@rugidcomputer.com. While support forums are monitored they are not the primary means of getting support. However chances are that someone else may have/had your same question.
-Any personal attacks, insults, rants, bad language or abuse of support staff or other forum users will result in deletion of such posts and immediate termination of forum access.
-Smile and have a great day!
2 posts
• Page 1 of 1
"Watch" while both serial ports are in use
by KTSeifert » Thu Mar 06, 2014 6:08 pm
Has anyone come up with a way to stop the comm on port 1 so that you can monitor variables through "Watch"? I so far have used keys to stop the Modbus read / write, but I think the port setup has to be changed, but I don't know what to change it to.
-
KTSeifert - Posts: 3
- Joined: Thu Mar 06, 2014 4:57 pm
Re: "Watch" while both serial ports are in use
by Cheryl » Thu Mar 06, 2014 9:35 pm
Hi Kevin,
Try changing the com setup to RUG9 protocol (mode 2) in the com setup module.
Try changing the com setup to RUG9 protocol (mode 2) in the com setup module.
- Cheryl
- Posts: 9
- Joined: Thu Feb 27, 2014 11:38 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest