Page 1 of 1

"Watch" while both serial ports are in use

PostPosted: Thu Mar 06, 2014 6:08 pm
by KTSeifert
Has anyone come up with a way to stop the comm on port 1 so that you can monitor variables through "Watch"? I so far have used keys to stop the Modbus read / write, but I think the port setup has to be changed, but I don't know what to change it to.

Re: "Watch" while both serial ports are in use

PostPosted: Thu Mar 06, 2014 9:35 pm
by Cheryl
Hi Kevin,
Try changing the com setup to RUG9 protocol (mode 2) in the com setup module.