Copy Program from PLC

A discussion of the RUG9/RUG5 support software and programming
Forum rules
To help everyone get the most out of the forums and keep this a friendly place containing useful information please keep in mind the following guidelines:

-Keep discussions professional and on topic.

-If you need immediate support please email While support forums are monitored they are not the primary means of getting support. However chances are that someone else may have/had your same question.

-Any personal attacks, insults, rants, bad language or abuse of support staff or other forum users will result in deletion of such posts and immediate termination of forum access.

-Smile and have a great day!

Copy Program from PLC

Postby Caleb » Thu Jul 02, 2015 11:19 am

Is there a way to download or copy a program off of a Rugid 9 PLC?

Posts: 1
Joined: Thu Jul 02, 2015 11:16 am

Re: Copy Program from PLC

Postby Cheryl » Mon Oct 05, 2015 11:40 am

Hi Caleb,
You probably already have an answer to this question by now but for others who may stumble upon this question the answer is no, there is not a way to download a program back off of a RUG9 (same with RUG5 and RUG3). For many reasons it's always important to safely maintain a copy of the program loaded into it; this, in my opinion, would also be true even if you could download a program back off a PLC.

Posts: 9
Joined: Thu Feb 27, 2014 11:38 am

Return to RUG9/RUG5

Who is online

Users browsing this forum: No registered users and 0 guests